Vertical Rollerskating

Vert-Skating-Forum

Message 6475 (22. Aug. 2008 02:47) (Tree)

Robert
the picture
Hey Bombe,

Thanks for the picture. Do you happen to have one of the bottom of your skates? If anyone on here can provide a picture of the bottom of your skates with sliders, I would appreciate it. I want to bring some ideas to a shop and see if they can make them for me.

Thanks,

Robert

: : ooopsss
  Write reply

Replies

Robert: Back to slider (21. Aug. 2008 04:13)
 Ok, I have finally decided to make slider and have reviewed all of the awesome diagrams. I see that most of the setups have a diagnol cut where the trucks are. I keep my trucks very very loose and am concerned they will rub on the slider. I am anxious to get this done so any suggestions and pictures of the bottom of your skates would be very helpful. I did re read the thread from March and the diagrams were awesome, but that part of my plate is not flat and slopes down. I am going to see about having a plastic fabrication shop do it for me, but am still open to trying it myself. I don't understand how you screw the slider into the plate? Also, can you thread the hole so that you can replace the slider?

Thanks,

Rob
  Write reply
BOMBE: slider (21. Aug. 2008 07:20)
 : Hope this picture may help you. Good luck.
  Write reply
bombe: the picture (21. Aug. 2008 07:21)
 : ooopsss
  Write reply
Robert: the picture (22. Aug. 2008 02:47)
 Hey Bombe,

Thanks for the picture. Do you happen to have one of the bottom of your skates? If anyone on here can provide a picture of the bottom of your skates with sliders, I would appreciate it. I want to bring some ideas to a shop and see if they can make them for me.

Thanks,

Robert

: : ooopsss
  Write reply
Go to the Vert-Skating-forum