Vertical Rollerskating


Message 3931 (3. Nov. 2007 22:38) (All next previous)

claudine (videos by claudine) (pictures by claudine)
the weight...
4 ounces each skate but I didnt want them to be too thin cause I like em, dont want them to break and thought its silly to worry over an ounce.

: They are about done. Just need to fine tune some of the sides if I want them looking pretty and make the holes bigger when I get the nuts. I made circles, they do line up even though the photo doesnt show it so, they are sturdy cause the jigsaw would grab it and throw it around and no breakin! I rounded the outside of the circle to ease going on/off. Its a good back workout! Tomorrow, mount the plates! I think this will be easy after the sliders lol. Measurements, done, just drill holes.
  Write reply


  • claudine: my sliders! (3. Nov. 2007 22:13)
  • Go to the Vert-Skating-forum