| I am confused? Well, I guess that's normal. It looks like those are inline skate chassis or plates. Are you going to attach those to your current plate?
: I found these, the bottom is solid so I just trim the ends to give the trucks room to move, drill 2 holes and holes in the plate with a tempered bit, secure with flat bolts, then its set.
:
: http://www.skates.com/photos/KFAB-2.jpg
:
: I like the idea using UHMW plastic, I'm not sure yet on the heaviness of it. My idea changed to this image, So I hollowed it all out:
: http://www.stonescape.net/~claudine/plate.jpg
:
: Pretty much Gambins idea! But I thought I would make a 2 inch long notch, 1/4 inch or so deep to clasp on. Then the outside edges I could knock off with a 45 degrees slant to ease getting on/off. Was thinking now just triangular shaped notch. But I'm not sure of freight costs for it and I must watch my money now.
|