Vertical Rollerskating


Message 12554 (8. Jun. 2010 21:14) (All next previous)

Vertic_Al (videos by Vertic_Al) (pictures by Vertic_Al)
Drill press
Agreed, not only does it lose its edge but you also run the risk of snapping the drill bit from the heat generated.

Also with cutting metal you should give a little space to allow you to deburr and file to a nice clean edge.

  Write reply


  • cephalopoid: cephalopoid's definitive build-a-skate-thread (19. May. 2010 11:56)
  • Go to the Vert-Skating-forum