Vertical Rollerskating


Message 12876 (26. Jun. 2010 12:15) (All next previous)

Bernhard (videos by Bernhard) (pictures by Bernhard)
screwing nuts on
I use two nuts to avoid the spinning bolt problem. First, a non-locking nut. It will normally pose no problem to screw on a non-locking nut (in the worst case, I use a side cutter to cautiously grip the bolt in its threads). Afterwars, the bolt is tight enough so I can screw on the lock nut. Of course, the bolt needs to be long enough to accept two nuts.
  Write reply


  • cephalopoid: cephalopoid's definitive build-a-skate-thread (19. May. 2010 11:56)
  • Go to the Vert-Skating-forum